Sliding Glass Door One Way Tint - When it comes to keeping your house in tiptop shape, nothing can be frustrating than a sliding glass door that will not slip. After all, what is the purpose of owning a beautiful glass door that leads out to a picturesque backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this report to notify you of the number 1 reason why your sliding glass door will not slip - and everything you can do about it! The number 1 reason why your sliding glass door will not side is that a lot of debris and dirt have clogged the wheels up and the course of your door panel. This isn't a difficult fix, but since most sliding glass doors are quite heavy, it is best if you've got another individual present to help you.
The first step is to analyze how your sliding glass door is repaired into the monitor. The vast majority of sliding glass doors have a strip that runs along the top of the framework that holds the doorways in vertical orientation, placing the wheels to fit neatly within the sliding path. To start, let us use a very simple screwdriver to remove that strip at the very top. When the strip is removed, gradually tilt the door from the frame, then remove it from the frame altogether. Turn the doorway on its side and also analyze the wheels in the base of the door. Bear in mind, some sliding glass doors can be upwards of 90 lbs, so either get some help or become quite confident on your physical skill.
When the door is on its side, you can closely examine the wheels and the monitor. Most commonly, you will find the wheels are full of soot and debris, and the track can also be likely quite dirty. To clean the brakes, then use compressed air and needle tip pliers. Take care to pull every single hair from the wheel bearings. It's prudent to be diligent at this measure, so you don't have to make a habit of the procedure. When the wheels are totally clean, spray a little bit of peppermint oil into the wheel bearings, spinning the wheel as you use the oil. (The ideal choice for your petroleum is DuPont's Teflon non invasive dry film lubricant.) It's equally important to clean out the track that the wheels rest on.
Use damp paper towels to remove the grit and soil, and then spray the penetrating oil along the track so it is well-applied. While you're at it, clean up all the "mating-edges" of the doorway. This is the point where the sliding door matches with any other surface of the door frame. A general rule of thumb is to just wipe down anything that looks dirty. Bear in mind, even if the dirt isn't always on the track itself, it can finally fall into the track causing your doorway to need down another wipe. If you notice any mating edges that feel tacky, have a paper towel and spray some oil on it, then wipe out the oil onto the tacky surfaces. After you've done all this, reinstall the doorway. You should notice immediately that the doorway is much easier to slip, and should require significantly less effort.
If for any reason that the door is still difficult to rollup, it is likely one of the following reasons: either your wheels are burnt out, or your sliding glass door is sitting too high on the track and is consequently hitting the top plate of the door frame. |} If your wheels are burned out, sadly, you are going to have to call the manufacture of your sliding glass door and request new wheels. Turn to the right to lift the doorway, or turn to the left to lessen the door.