Glass Cabinet Doors Only - When it comes to keeping your home in tiptop shape, nothing could be frustrating than a sliding glass door which won't slip. After all, what's the purpose of owning a beautiful glass door which leads out to a picturesque backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this article to inform you of the number 1 reason why your sliding glass door won't slip - and everything you can do about it! The number 1 reason why your sliding glass door won't drawback is that a lot of dirt and debris have clogged up the wheels and the course of your door panel. This is not a difficult fix, but because nearly all sliding glass doors are quite heavy, it is wise if you have another person present to help you.
The first step would be to examine how your sliding glass door is fixed into the track. The vast majority of sliding glass doors have a strip which runs across the top of the framework that holds the doorways in vertical alignment, positioning the wheels to fit neatly over the sliding track. To begin, let us use a simple screwdriver to remove that strip on very top. When the strip is removed, gradually tilt the door out of the frame, then remove it out of the frame completely. Turn the doorway on its side and also examine the wheels at the bottom of the door. Bear in mind, some sliding glass doors could be upwards of 90 lbs, so either acquire some help or become very confident on your physical ability.
Most commonly, you will discover the wheels are filled with soot and debris, and the track can also be probably very filthy. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every single hair out of the wheel bearings. It's prudent to be diligent in this step, so you don't have to make a custom of this procedure. When the wheels are completely clean, spray a little bit of penetrating oil to the wheel bearings, turning the wheel as you apply the oil. (The best choice for the oil is DuPont's Teflon non invasive dry film lubricant.) It's just as important to clean out the track that the brakes rest on.
Use moist paper towels to remove the grit and dirt, and then spray the penetrating oil across the trail so it is well-applied. While you're at it, clean up all of the "mating-edges" of the doorway. This is where the sliding door matches with another surface of the door frame. A general guideline is to just wipe down anything which seems filthy. Bear in mind, even when dirt is not necessarily on the trail itself, it may eventually fall into the trail causing your doorway to need down another wipe. If you notice any breeding advantages that feel tacky, take a paper towel and spray some oil on it, then wipe out the oil onto the tacky surfaces. After you have done all this, reinstall the doorway. You should note immediately that the doorway is much easier to slip, and should require significantly less effort.
If for any reason the door remains difficult to rollup, it is likely one of these reasons: either your brakes are completely burned out, or your sliding glass door is sitting too high on the trail and is thus hitting the top plate of the door frame. |} If your brakes are burnt out, sadly, you'll have to call the manufacture of your sliding glass door and request new wheels. If on the other hand, your doorway is hitting the top plate of your door frame, you can correct this by locating the screw holes at the very bottom of your sliding glass door. On most sliding glass doors, there are two screws which could be turned using either a flathead screwdriver or an alan wrench. Switch to the right to lift the doorway, or turn to the left to lessen the door.