Front Door Frosted Glass Film - If it comes to keeping your home in tip-top shape, nothing can be more annoying than a sliding glass door that will not slide. After all, what's the purpose of having a beautiful glass door that leads into a scenic backyard if the damn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I decided to write this article to inform you of the number 1 reason why your sliding glass door will not slide - and everything you can do about it! The number 1 reason why your sliding glass door will not side is that a lot of dirt and debris have clogged up the wheels and the track of your door panel. This isn't a hard fix, but since most sliding glass doors are quite heavy, it is best if you have another person present to help you.
Step one is to analyze how your sliding glass door is repaired into the monitor. The vast majority of sliding glass doors have a strip that runs across the surface of the framework that holds the doors in vertical orientation, placing the wheels to fit neatly within the sliding track. To start, let us use a very simple screwdriver to remove that strip on top. Once the strip is removed, gradually tilt the door out of the frame, then eliminate it out of the frame completely. Turn the door on its side and also analyze the wheels in the base of the door. Bear in mind, some sliding glass doors can be upwards of 90 lbs, so either get some help or become very confident in your physical skill.
Most commonly, you'll discover the wheels are filled with soot and debris, and the track can also be likely very filthy. To wash the wheels, use compressed air and needle tip pliers. Take care to pull every single hair out of the wheel bearings. It is wise to be diligent in this measure, so you don't have to make a custom of this procedure. Once the wheels are totally clean, spray a little bit of peppermint oil to the wheel bearings, spinning the wheel as you apply the oil. (The ideal option for the oil is DuPont's Teflon non-stick dry film lubricant.) It is equally important to clean out the track that the brakes rest on.
Use damp paper towels to remove the grit and soil, and then spray on the penetrating oil across the track so it is well-applied. Use a clean paper towel to ensure it is evenly applied. While you're at it, clean up all of the "mating-edges" of the door. This is where the sliding door matches with any other surface of the door frame. A general rule of thumb is to simply wipe down anything that looks filthy. Bear in mind, even if the dirt isn't always on the track itself, it can finally fall into the track causing your door to need another wipe down. If you notice any breeding advantages that feel sticky, take a paper towel and spray some oil on it, then wipe out the oil onto the sticky surfaces. After you've done all this, reinstall the door. You should note right away that the door is much simpler to slide, and should require significantly less effort.
When for any reason that the door remains difficult to rollup, it is likely one of the following reasons: either your brakes are burnt out, or your sliding glass door is sitting too high on the track and is thus hitting on the upper plate of the door frame. |} If your brakes are burned out, sadly, you'll have to call the manufacture of your sliding glass door and ask new wheels. Switch to the right to lift the door, or turn to the left to lessen the door.